StarTech 10/100 VDSL2 Ethernet Extender Kit over Single Pair Wire

The 110VDSLEXT VDSL Ethernet extender kit lets you span a 10/100 network over extremely long distances (up to 1km) while still maintaining high-speed network connectivity, allowing you to run the connection over standard RJ45 cabling, existing RJ11 phone lines, or any other set of single pair wires. The VDSL (VDSL2) kit is simple to install and provides an out-of-the-box solution as both the Ethernet-VDSL extender and receiver units are included.

• IEEE 802.1Q VLAN tag transparent
• Selectable CPE and CO mode via DIP switch
• Supports flow control for Fast Ethernet (pause frame or Back Pressure)

Hardware:
• Industry Standards: IEEE 802.3/802.3u/802.3x 10/100 Base-T Auto-Negotiation, Auto-MDI/MDI-X, On-board surge protection, VDSL2 ITU-T G.993.2, VDSL ITU-T G.993.1, and VDSL2/VDSL ITU-T G.997.1 compliant

Performance:
• Max Distance: 1 km (0.6 mi)
• Maximum Data Transfer Rate: 0m - 100Mbit/s, 300m - 75Mbit/s, 1km - 10Mbit/s

Connector(s):
• Local Unit Connectors: 2 - RJ-45 Female
• Remote Unit Connectors: 2 - RJ-45 Female

Indicators:
• LED Indicators: 3 - LAN: ACT/LNK, 10/100 Mbps, Half/Full Duplex, 3 - VDSL: Power On/Off, CO/CPE, Idle/Trained/Link

Power:
• Output Voltage: 12V DC
• Power Source: 2 AC Adapters Included

Physical Characteristics:
• Color: Black
• Product Height: 22 mm
• Product Length: 95 mm
• Product Width: 72 mm
• Weight of Product: 173 g

• Note: You have the ability to use up to four sets over a single Cat5e or Cat6 cable which can be used as separate LAN (or VLAN) connections, or bridged into a trunk line for additional speed/bandwidth over long distances (Up to two sets only over standard Cat5).

• 1x Ethernet VDSL Extender
• 1x Ethernet VDSL Receiver
• 2x RJ-45 to VDSL Cable
• 2x Power Adapter
• 1x Instruction Manual