Platinum Tools LANSeeker Cable Tester & Tone Generator

The Cable Prowler combines network testing (physical layer and link), cable verification & troubleshooting and PoE voltage testing in a handheld tester with a full-colour display; all with the capability of saving and printing tests results from a personal computer.

Cable Verification & Troubleshooting:
• The Cable Prowler provides full cable testing on any category network, coax, or telephone cable. It will display wire map, numbered ID remotes, and any faults, including shorts, opens, mis-wires, split pairs, and reverses. The full-featured Cable Prowler measures cable length (using TDR technology) and generates tone levels for signal tracing and cable identification on all pairs, a selected pair, or a selected pin.

PoE Voltage Testing:
• The Cable Prowler enables quick identification of a network drops link capability and current link status. Cable Prowler also tests the presence of PoE on the network drop and what class of PoE per IEEE 802.3 af/at with load test for voltage drop. These network tests can also be saved for record keeping and printing.

Cable Types Supported:
• Shielded or unshielded, CAT3, CAT4, CAT5, CAT5e, and CAT6
• Minimum cable length for testing split pairs: 1 m (3 ft)
• Maximum cable length for testing: 305 m (1,000 ft)
• Coax cable: 100 Ohms maximum DC resistance, center conductor plus shield

Environmental:
• Operating Temperature: 0 to 50ºC (32 to 122ºF)
• Storage Temperature: -20 to 70ºC (-4 to 158ºF)
• Humidity: 10 to 90%, non-condensing
Dimensions (W x D x H): 145 x 72 x 30mm
Weight: 162g