Dynalink X9667R VDSL2 - Broadband Residential Gateway Model Number: X9667R

Dynalink X9667R VDSL2 - Broadband Residential Gateway

Overview

The X9667R is a product line of VDSL2 Ethernet Gateways that complies with various VDSL1 / VDSL2 standards, and provides unprecedented broadband service over a single pair of copper wire. It integrates four ports 10/100 Base-T/TX Ethernet switch that can easily connect to any PC or LAN in home or small office environments. Optionally the wireless LAN support frees the hassle of
troublesome in-home wiring. Quality of multimedia service is ensured with its powerful traffic control and management over layer 2 or 3. While the NAT / PAT technologies share the broadband connection to all its LAN clients for all prevailing Internet applications, the embedded firewall keeps out those malicious attacks and intrusions.
Network management is implemented so it can be easily configured and managed by the service provider.

Features

• Compliant with VDSL2 and VDSL standards with programmable support of band plan 997, 998, FX and
China; capable to support VDSL2 profiles up to 30a
• DMT-based transport can support symmetric line rates up to 100 Mbps downstream and 100 Mbps upstream
at short loop
• Supports packet transfer mode with HDLC or EFM framing for Ethernet over VDSL
• Integrated Ethernet switch features non-blocking switching performance as well as automatic speed sensing
and crossover detection-and-correction capability
• Optional 802.11g WLAN supports up to 54Mbps transmission rate as well as Wi-Fi WEP/WPA/WPA2 for
data security
• Integrated hardware accelerated layer 2 switch with Traffic classification and QoS supports, including IP QoS
based on IP
• IP routing, NAT, PAT, SPI firewall, packet filtering
• Web/HTTP, CLI/Telnet,for network management

Specifications

Hardware

WAN Interface
• 2-wire loop, 100 ohms line impedance with RJ-11 connector
• Drive up to 14.5dBm transmit power
• Comply with ITU-T G.993.1, G.993.2, ANSI T1.424-2004, ETSI TS 101 270-1 and TS 101 270-2 FS306

Local Interface
• Four 10/100 Base-T Ethernet ports with RJ-45 connector
• Complies with IEEE 802.3/3u, and supports automatic 10/100 Mbps speed-sensing as well as MDI / MDI-X crossover detection-and-correction
• Option: One USB1.1 device (slave) port, type B connector
• Option: Integrated 802.11b/g wireless LAN Access Point

Status Indicators
• PPP – Continuous GREEN indicates PPP connection is established; Continuous RED indicates that PPP link is disconnected
• LAN – Continuous ON indicates Ethernet is active, and blinking while transmitting data
• DSL – Slow flash indicates signal searching, then continuous ON when VDSL link is ready
• WLAN – Continuous ON when WLAN is ready
• USB – Continuous ON when USB link is ready
• PWR – Continuous GREEN when the power supply is properly connected; Continuous RED indicates boot failure.

OAM&P
• Configuration and Management can be performed through HTTP/ Web or Telnet/ CLI over IP
• Reset button to restore the factory defaults
• Button to enable or disable wireless functionality

Environment
• Operation Temperature and Humidity: 0°C ~ 40°C, 5% ~ 95% (non-condensing)
• Storage Te mperature and Humidity: -20°C ~ +85°C, 5% ~ 95% (non-condensing)

Power
• AC adapter: input 100 ~ 240 VAC @ 50/60 Hz; output 12 VDC 1.5 Amp
• Power consumption: Less than 18 Watts

Physical Dimensions (Main body)
• (W × D × H) 255 mm × 160 mm × 42 mm

Certificates
• EMC: CE – EN300386, EN301489, EN300328; FCC part 15b/15c, part 68
• Safety: LVD – EN60950, UL60950-1:2003

Software

VDSL
• Supports band plans 997, 998, FX and China; VDSL2 profiles 8a/b/c/d, 12a/b, 17a, 30a and various PSD masks (Not all profiles and PSD masks are supported right now)
• DMT (Discrete Multi-Tone) modulation supports packet transfer mode
• Supports Ethernet-over-VDSL (EoVDSL) using either HDLC or EFM framing

Bridging
• 802.1D Bridging
• Automatic learning bridge up to 2,048 MAC addresses
• Supports port-based VLAN or IEEE 802.1Q tagged VLAN
• IP M ul ti cast a nd IGMP s noopi ng
• MAC address filter

Routing
• Dynamic routes: RIPv1 or RIPv2; Static routes
• PPP client with PAP / CHAP authentication
• IGMP proxy

Networking / Transport Layer Protocols
• DHCP server and client
• DNS relay and Dynamic DNS support

Firewall / NAT
• Stateful packet i nspection firewa ll
• Access control list, based on IP and port
• Port forwarding, virtual server
• Supports one DMZ host
• ALG support includes: FTP, PPTP, L2TP, IRC, NetMeeting, IPSec, S IP, etc.

Traffic classification and QoS Supports
• QoS determi ned by packet type, source IP address / port, destination IP address / port,
• WFQ with configurable weightings
• IP QoS scheduling

Wireless LAN Security
• Supports 64 or 128 bits WEP encryption with authentication via Pre-s hared ke y, as well as
• Wi-Fi Protected Access (WPA) and WPA2, with TKIP or AES-CCMP encryption
• Access control based on MAC address
• Capable to hide configurable SSID
• Two SSID groups with different security settings are supported in the management web

Configuration and Management
• Web/ HTTP or CLI/ Telnet
• Supports UPnP
• Supports PING for connection diagnostic
• SNTP client for network time synchronization
• Supports syslog
• SNMP v1 and v2c agents
• Supports DSL forum TR-069 for remote management

While every attempt is made to ensure the information provided is accurate, we are not responsible for any product image and information errors and omissions.